RTI T1-B Instrucciones de operaciones descargar pdf (Pagina 16)

Universal System Controller

T1-B

CHAPTER 3 | OPERATION

Using a scissors, individually cut-out the keycaps that will be used:

After the keycap is cut out from one of the sets, press it over an empty keycap

button. Make sure to press down rmly on the keycap until it is rmly seated.

Note: the keycaps can be permanently secured by using an adhesive that bonds

to silicon rubber. The following instant adhesive glue works well and is readily

available:

Silicon Adhesive: Loctite PRISM

401 (p/n 40104)

U.S. Resellers: Contact East: # 173-606

McMaster-Carr: # 74765A63

Grainger: # 3KE58

Follow these steps to apply the Loctite #401 adhesive:

1. Apply a thin layer of the adhesive to the entire top surface of the

desired keycap button.

2. Press the desired keycap over the button.

3. Press down rmly on the keycap for 15 seconds.

Repeat these steps for each keycap on the T1-B. When nished applying

keycaps, replace the bezel on the T1-B.

PROGRAMMING THE T1-B

The T1-B is programmed using RTI’s Integration Designer

software.

A PC running Windows XP

, Windows Vista

or higher with a USB port is

required. The required USB cable is included with the RTI IR-PRO dealer kit.

Note: The T1-B will not operate normally while connected to a PC’s USB port.

Make sure you disconnect it from the computer to navigate pages or transmit

commands. In addition, the T1-B will not be able to sync with a computer’s USB

port while it is transmitting a command or running a macro.

Cut along the channels

that are the closest to

the keycap walls.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Sin comentarios

RTI T1-B Instrucciones de operaciones Pagina 16