RTI XP-3 Manual de usuario descargar pdf (Pagina 4)

 

 

DigiLinX

™

Application Note

Application Note: 030061

NetStreams , DigiLinX, ControLinX, MediaLinX, SpeakerLinX and SwitchLinX are Trademarks of NetStreams LLC.

main +1 512.977-9393 / fax +1 512.977.9398 3600 W. Parmer Lane, Ste. 100; Austin, TX 78727

You should always set Baud Rate to 9600, Parity to None, Data Bits to 8 and Stop Bits to 1. The port will

depend on the output port from your RTI processor; just make sure to match the output port selection in

Integration Designer to the physical output port that your RS-232 cable is plugged into.

DigiLinX ASCII commands start with a “#” then use an “@” to designate the zone or service being

addressed. In this case, we are addressing the Player in the Living zone. Another “#” and the specific

command addressed to this service, in this case “Active On” turns on the zone. Finally, the command

must be finished with a carriage return, or “\r”.

ASCII commands can be hand written if you know the syntax. However, the easiest way to generate

ASCII commands is to use the macro tool in DigiLinX Dealer Setup! To open the macro tool, click

“Macros” at the top left corner in DigiLinX Dealer Setup.

-Cont’d-

1 2 3 4 5 6 7 8

Sin comentarios

RTI XP-3 Manual de usuario Pagina 4