RTI XP-3 Instrucciones de operaciones descargar pdf (Pagina 13)

It’s Under Control

CHAPTER 3 | INSTALLATION AND OPERATION

MOUNTING

The XP-3 can be wall mounted (details below) or free standing.

The XP-3 does not need to be mounted near the equipment being

controlled. The IR output ports and the optional Power Sensor modules

can be extended up to 1000 feet. If RS-232 control ports or the CM-232

Communication Module are used, the distance limitation is usually 50 feet

depending on baud rate.

MOUNTING INSTRUCTIONS

To mount the XP-3 to a wall, shelf, or cabinet you must use the enclosed

mounting plate.

• Level and anchor XP-3 mounting plate to desired wall, shelf, or cabinet

by screwing appropriate wall, shelf, or cabinet fasteners (not included

with the XP-3) through the mounting plate fastener holes.

• When mounting the XP-3, be certain to choose a safe location (e.g.

away from electrical junction boxes, circuit breakers, wet locations,

etc.)

• Afx the XP-3 to the mounting plate by placing the XP-3 channel

locks located on the rear of the XP-3 over the XP-3 channel lock clips

located on the front of the mounting plate. Slide the XP-3 down until

the channel lock clips lock into place.

XP-3 Mounting Plate

Mounting Plate Fastner Holes

XP-3

Channel

Locks

Rear of XP-3

XP-3 Channel

Lock Clips

XP-3 Channel

Lock Clips

XP-3

Channel

Locks

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

Sin comentarios

RTI XP-3 Instrucciones de operaciones Pagina 13